Make your fine art jump out with a Wendelighting Contour Framing projector. With Wendelighting, we can illuminate only your art piece or even multiple pieces of artwork with a single projector. We are a proud Texas Distributor for all Wendelighting projectors and not only install beautiful low profile projectors, but also can service your existing projector, replace bulbs, and cut new templates if you have new artwork or move your existing projector to a new location. There is absolutely no substituting for Wendelighting. Many cheap imitations use underpowered low voltage lamps which are barely visible.

 

The process is straightforward, but requires planning and a skilled template cutter: First we install the housing and projector and make adjustments to lenses involved. Next we cut out a custom template for each piece of artwork you wish to illuminate. Please note the following disclaimer when considering a Wendelighting projector.

Notes:

• If object(s) to be illuminated has reflective surface, the project light source(s) will be visible on the surface. Furthermore, the surface will reflect the same surface pattern that will be visible on the floor below (art lighting) or ceiling above table.
• There is a possibility that the existing construction might not accommodate the projector (s) due to vertical clearances, joist spacing, and/or other obstructions.
• The light confinement(s) will have a blue edge along their perimeters.
• If art is glossy, glare on art will be visible.
• Deep frames may cast shadow onto artwork.
• The light confinement(s) cannot stop exactly on an edge. Either darkness will exist on the art or spill light will exist onto the frame or adjacent wall.
• Single projector installed off center of art will result in brighter illumination on off center side.
• Top of art will be brighter than bottom and is more evident on tall paintings.
• Light confinement plates can slip.
• Wendel projectors are not Air Tight Rated.
• Wendelighting recessed projectors are non-IC rated, insulation must be kept away from fixture.

Depending on your art work or sculpture, we can use a variety of light fixtures to create the perfect look. Our favorite is using angled low voltage MR-16 lamps which allow us to use different beam angles to match your art work. With those fixtures we also have the option to use soft focus or elongation lenses to further customize the lighting to your work. We also use different varieties of xenon lamps, puck lights and a variety diffusing lenses in order to create the best look for your home.

Accent lighting is not as precise as using a framing projector since it does not contour your art work; however, in our expert hands, we can adjust the light beam to customize the light to match the piece you want to illuminate very beautifully at a very affordable price.